After surfing for a long time, do you think the surfboard traction pad has no initial adhesion? At this time, it's time to consider changing an surfboard traction pad.
Tools / raw materials:
Blade
Wax comb / hard card
Kitchen Towel
Mineral turpentine, or other liquid that can dissolve glue residues without damaging the surfboard.
Step 1: the surfboard traction pad is like a sticker. It is recommended to tear it off as a whole as possible, otherwise there will be adhesive residue on the surfboard, which will bring great trouble to the cleaning behind you. Therefore, it is recommended that you use the blade to slowly cut in the side, and then carefully tear it.
Step 2: after the surfboard traction pad is torn off, continue to scrape off the adhesive with a blade. Please be careful not to scratch the board.
Step 3: soak the kitchen paper towel in turpentine, place it at the end of the board where there is adhesive, cover it for 5-10 minutes, and the adhesive will soften slowly.
Step 4: scrape off any adhesive remaining on the tail surface with a wax comb or hard card and wipe it with a paper towel. At this time, the place where the anti-skid pad is pasted will be the same as the new one.
Step 5: dry all the water with a dry paper towel, and then you can stick a new anti-skid pad.
Step 6: simply position before pasting, and then just like pasting stickers, it's simple and fast. You can't go into the water until the foot pads are completely bonded.